Bradford White 50 Gal Tall Power Vent (TTW®) Gas RG2PV50T6N

The TTW® Models Feature:

■ ENERGY STAR® Qualified — Some models qualify for the September 1, 2010 minimum ENERGY STAR® EF requirement, as well as most utility rebate programs.
■ Bradford White ICON System™ — Intelligent gas control with spark to pilot ignition system eliminates the constant burning pilot. This results in savings of pilot gas during standby periods (120 V.A.C.). -- Enhanced Performance—Proprietary algorithms provide enhanced First Hour Delivery ratings and tighter temperature differentials. -- Advanced Temperature Control System—Microprocessor constantly monitors and controls burner operation to maintain consistent and accurate water temperature levels. -- Intelligent Diagnostics — An exclusive green LED light prompts the installer during start-up and provides ten different diagnostic codes to assist in troubleshooting.
■ Power Vented Water Heater — Designed for installations where atmospheric units cannot be used. Exhaust gases are vented under positive pressure directly out of the building through the roof or the wall.
■ Powerful Blower Motor — Our significantly quiet design has greater resistance to outside winds and the power to vent in many difficult venting situations. -- Ten Foot Power Cord—Included (120 VAC).
■ Horizontal and Vertical Venting — PVC, ABS or CPVC (Maximum equivalent vent length on reverse side).
■ Advanced ScreenLok® Technology Flame Arrestor Design — Flame arrestor is designed to prevent ignition of flammable vapor outside of the water heater (excluding RG1PV55H6N & RG2PV75H6N).
■ Flammable Vapor Sensor — Electronic sensor prevents burner operation if flammable vapors are detected. The sensor will also prevent operation if there is ongoing flammable vapor burn inside the combustion chamber (excluding RG1PV55H6N & RG2PV75H6N).
■ Maintenance-Free — No regular cleaning of air inlet openings or flame arrestor is required under normal conditions (excluding RG1PV55H6N & RG2PV75H6N).
■ Sight Window — Offers a view into the combustion chamber to observe the operation of the pilot and burner.
■ Factory-Installed Hydrojet® Total Performance System — Cold water inlet sediment reducing device helps prevent sediment build-up in tank. This increases first hour delivery, while minimizing temperature build-up at top of tank.
■ Vitraglas® Lining — Bradford White tanks are lined with an exclusively engineered enamel formula that provides superior tank protection from the highly corrosive effects of hot water. This formula (Vitraglas®) is fused to the steel surface by firing at a temperature of over 1600°F (871ºC).
■ Non-CFC Foam Insulation — Covers the sides and top, reducing the amount of heat loss. This results in less energy consumption, improved operation efficiencies, and jacket rigidity.
■ Water Connections — 3/4" NPT factory-installed true dielectric fittings.
■ 3/4" NPT Side Connections — (RG2PV50H6N, RG1PV55H6N, and RG2PV75H6N only).
■ Factory-Installed Heat Traps — Design incorporates a flexible disk that reduces heat loss in piping and eliminates the potential for noise generation.
■ Protective Magnesium Rod — (RG1PV55H6N has 2).
■ T&P Relief Valve — Installed.
■ Thermostatic Mixing Valve (ASSE Approved) — Included (RG1PV55 



Product Literature
Quick Service Guide
Warranty
Operation Manual
Service Manual
Parts List